TracksEasy
Track Tension Adjustment
Adjust rubber track tension to prevent slipping or premature wear.
Estimated: 20-30 mins
2 model-specific guides
Model-Specific Guides
General Guide
Track Tension Adjustment Procedure
Proper track tension is critical for performance and longevity. Too loose causes slipping; too tight causes accelerated wear.
Tools Required:
Grease gunRuler or tape measureWrench for relief valve
Safety Notes
- • Support machine safely when track is raised
- • Stand clear when loosening relief valve - grease exits under pressure
General Steps:
1
Park machine on level ground and lift one track off the ground.
2
Measure track sag at midpoint between idler and drive sprocket.
3
Compare measurement to specification (typically 10-20mm sag).
4
Locate the track tensioner grease fitting.
5
To tighten: Add grease to push idler forward.
6
To loosen: Slowly crack the relief valve to release grease.
Loosen relief valve gradually - grease is under high pressure.
7
Recheck sag measurement and adjust as needed.
8
Repeat for opposite track.
Video Resources
No videos added yet.
Add helpful YouTube tutorials for this repair job.